Application of the BIOLOG system for characterization of Serratia marcescens ss marcescens isolated from onsite wastewater technology (OSWT).
AbstractThe scope of this study was to apply the Biolog system to identify and characterize a Serratia strain isolated from the surface of black plastic pieces which constitute the fluidized bed filter (onsite wastewater technology, OSWT). The preliminary isolation of the strain was done in the medium with tetracycline at a 16 mg/l concentration. To characterize the isolated strain, the following Biolog methods were applied: (1) EcoPlates microplates for evaluation of physiological profiling, (2) GEN III OmniLog® ID System for identification of the isolate, and (3) phenotypic microarrays (PM) technology for evaluation of sensitivity to antibiotics (PM11 and PM12). Results were recorded using the original OmniLog® software. The Serratia strain was identified as Serratia marcescens ss marcescens with similarity index 0.569. The same identification was obtained by the 16S rDNA analysis. PM analysis showed an enhancement of phenotype (resistance or growth) of this strain to 35 antibiotics. The loss of phenotype (sensitivity or non-growth) was observed only for 5 antibiotics: lomefloxacin (0.4 µg/ml), enoxacin (0.9 µg/ml), nalidixic acid (18.0 µg/ml), paromomycin (25.0 µg/ml) and novobiocin (1100 µg/ml). This study acknowledges that the methods proposed by the Biolog system allow correct and complete identification and characterization of the microbes isolated from different environments. Phenotypic microarrays could be successfully used as a new tool for identification of the multi-antibiotic resistance of bacteria and for determination of the minimal inhibition concentrations (MIC).
Acta Biochimica Polonica is an Open Acess Journal published on Creative Commons Atribution and Share Alike Licence